Installation

Estimated reading: 1 minute

Use the go-pro mount itself to adjust pitch, then the yaw by loosening the height/yaw screw on Aerosensor’s stem (height adjuster) and rotating the unit. 

Do not use the aerosensor base to pivot, this can cause damage to the stem.

When installing, it is important to have Aerosensor as far forward and low as possible that the stem allows to minimise influence of rider position.

  • The base must be at least 20mm above the front wheel.
  • It should be centred on the bike and facing forwards. Use the front wheel as a reference for yaw alignment.
  • Aerosensor should be level – use a horizontal object to the side of the bike (like floor markings), and visually align the bottom of Aerosensor with the horizontal line. An example is shown below, where a horizontal line on the wall is used. Note that the device is tolerant to pitch misalignment within +/-5°.
Share this Doc

Installation

Or copy link

Articles

Me old mucker bamboozled horse play fantastic skive off baking cakes knees up lurgy spiffing, Harry bog wind up say are you taking the piss porkies hunky-dory, blower pardon you you mug pear shaped pukka get stuffed mate lavatory.

Me old mucker bamboozled horse play fantastic skive off baking cakes knees up lurgy spiffing, Harry bog wind up say are you taking the piss porkies hunky-dory, blower pardon you you mug pear shaped pukka get stuffed mate lavatory.